Model NO.: 9929
Transmission Medium: Cable
Lightning Protection: With Lightning Protection
Net Weight: 0.6kg
Impedance: 50 Ohm
Product Keyword: GSM Signal Booster
Type: Signal Repeater
Certification: ISO, GS, RoHS, CE
Dimensions (D*W*H ): 125*110*25(Mm)
Operating Temperature: -10°c ~ 55°c
Mtbf: >50000 Hours
Installation Type: Wall Installation
Trademark: signal booster
850mhz signal repeater gsm signal booster
dual band repeater gsm parameter data :
|Gain||60 ±2 dB||60±2dB|
|Ripple in Band||≤5dB|
|Spurious Emission||9KHz~1GHz||≤ -36 dBm|
|1GHz~12.75GHz||≤ -30 dBm|
|Power Supply||AC:100~240V, 50/ 60Hz;DC:5V 2A|
|Power Consumption||< 5W|
|RF Connector||N-Female N|
|Dimensions (D*W*H )||125*110*25(mm)|
|Installation Type||Wall Installation|
|Operating Temperature||-10°C ~ 55°C|
Why we should buy mobile signal repeater/ signal booster/ CDMA amplifier :
Cell phone becomes especially helpful when people get into critical situations. In case of emergency a timely call can save somebody's life.
Unfortunately, there are still some places where one can find themselves "out of coverage". Usually those places are either too far from the cell phone base station or located inside underground constructions, for example:
· Parking lots, tunnels
· Big stores, office buildings
· Cars, boats etc.
· House in remote areas etc
How is mobile phone signal repeater GSM/DCS/ 2G/3G/4G WORKING ?
?The outside antenna catches the low signal from the mobile base station and delivers it to the cell phone
amplifier through the connection cable (coax).
?After the signal is accepted by the phone amplifier, the device amplifies it.
?Then this amplified signal goes through the connection cable (coax) to the inside antenna.
?And after that, the amplified signal transmits to the cell phone.
A regular repeater CDMA consists of:
5dB outdoor antenna
3dB indoor antenna
RG6-50 OHM outdoor Coaxial Cable-10m
AC power supply
|Whole Package Weight||1KG|
|Whole Package Size||310x130x110mm(L x W x D)|
Features of mobile phone signal amplifier
A. High-gain linear power amplifier
B . ALC and AGC function technology ,
C. Ultra-low noise receive amplifier
D. There is no interference to the base station ,right after the opening of the original system and the base station without the need to adjust parameters ,
E. Stable and reliable electromagnetic compatibility design .
F. The base station dose not cause an increase in background noise ,but will not lead to a decline in the quality of the base station communications
G. With full-duplex communication mode .
H. dispel the heat effective reasonable ,the structure is pretty ,the volume is suitable .
Signal repeater Installation diagram (very convenient and easy to install)